3D Print GLOWING ColorFabb XT PLA Filament on PrintrBot

Difficulty: Star LitStar LitStar UnlitStar UnlitStar Unlit (2/5)

Glow in The Dark Peace and Love Heart

It is a mesmerizing video to watch… I use the PrintrBot Simple to 3D print glow in the dark ColorFabb XT PLA Filament. Excuse the quality as this video was shot in complete darkness, and brightened up in post processing.

We used the silicone heated bed set to 65°C and an Extra Wide Roll of Blue Painters Tape for good bed adhesion. My hot end is heated pretty high for PLA, all the way up to 235°C. You might have luck with a little lower temperature but higher definitely will require more heat than normal for PLA.

If you’d like to see more please drop a comment below, email me directly using admin@triplemike.com, or hit me up at any of the social links below with your comments and suggestions.

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.